If a direct communication attempt fails, the device will try to establish a routed communication, through other modules, which will be signalled by visual indicator pulsing yellow. Visual indicator pulsing green – Dimmer 2 attempts to establish a direct communication with the main controller.To exit Z-Wave range test, press the B-button briefly.Visual indicator will indicate the Z-Wave network’s range (range signalling modes described below).Press and hold the B-button until the visual indicator glows violet.Testing may stress the network, so it is recommended to perform the test only in special cases. To make Z-Wave range test possible, the device must be added to the Z-Wave controller. Close the wall switch box and turn on the mains voltage.Turn off the mains voltage, then arrange the device and its antenna in a wall switch box.After successful calibration the device will be turned off by default.Wait around 30s for the calibration process to end, light may blink during the process.
1 (has the option of entering the device in learning mode) Length of wires used to connect the control switch should not exceed 20m.Electrical switches used in installation should be compliant with the relevant safety standards.Dimmer 2 should be installed in a wall switch box compliant with a relevant national safety standards and with depth no less than 60mm.Connect only in accordance with one of the diagrams.When connecting FIBARO Dimmer 2 act in accordance with the following rules:
Remote elv dimmer for led lights manual#
Connecting the FIBARO Dimmer 2 in a manner inconsistent with manual may cause risk to health, life or material damage.
0 kommentar(er)
